12 Head Industrial Mist Maker Ultrasonic Fogger Mist Atomizer For Pool Rockery Balcony landscape Humidifiers

Precautions for using atomizer landscape When using this atomizer, please choose a DC power supply with an output power greater than 300W and an output voltage of DC46 ± 2V.When using a ring transformer, the square bridge must be equipped with aluminum heat dissipation fins of 5050mm or more, and a thin lay…

Send Inquiry

Chat Now

12 Head Industrial Mist Maker Ultrasonic Fogger Mist Atomizer For Pool Rockery Balcony landscape Humidifiers

Precautions for using atomizer landscape

When using this atomizer, please choose a DC power supply with an output power greater than 300W and an output voltage of DC46 ± 2V.
When using a ring transformer, the square bridge must be equipped with aluminum heat dissipation fins of 5050mm or more, and a thin layer of heat dissipation paste must be applied between the square bridge and the aluminum heat dissipation fins.
When multiple atomizers are used in the same container, the shells of each atomizer must be conductive to each other to prevent electrical corrosion of the shells.
The fog generated by this atomizer must be forcefully eliminated by a fan, and each group of atomizers should reserve a flat space of 600cm2 to avoid excessive water temperature and shorten the service life of the atomizer.
This atomizer is suitable for atomizing neutral liquids (pH value 5-8). Acidic liquids will corrode the shell and atomizing plates, while alkaline liquids will affect the atomization amount, reduce the lifespan of the atomizer and atomizing plates, and cause water level switch failure and damage to the atomizer.
During the installation process, please do not damage the water level switch to prevent it from malfunctioning and causing the atomizer to lose control. After the water level switch is damaged, it should be stopped from use, otherwise the atomizer may dry out and further damage the atomizer. At this point, it needs to be repaired by professional maintenance personnel before use.
When the atomizer works normally, please do not put your hand on the top of the spray chamber of the atomizer to prevent ultrasonic damage.
This atomizer must be in water to function properly. Before use, please put it in water and then turn on the power, and ensure that the atomizer surface is in a watery state to avoid damage to the atomizer.
Before stopping using the atomizer, please disconnect the switch power supply first, and then remove the atomizer from the water.